This is an indispensable part of the bearing manufacturer industry. You can pay attention to bearings and their technology, and see how bearing maintenance in different fields can open up new platforms for applications with more faults.

When using large paired bearings, we need to put forward the following requirements for the service life and service life of the bearings, and pay attention to the lubrication state during installation and use, such as the lubrication state of the oil, load, etc. The lubrication type depends on the general power and work requirements.

Next, let's take a look at how to better carry out repairs. Firstly, we need to install and maintain bearings. When cleaning and maintaining, it is necessary to pay attention to cleaning and operation in order to timely remove residual lubrication and dirt. At the same time, we also need to pay attention to lubricants and pollution during operation, as well as contaminated ozone skin, such as bearings, screws, etc.

When cleaning and maintaining, we need to pay attention to cleaning and maintenance. Typically, cleaning is carried out by changing the size of the inner surface, surface roughness, and the distance between the equipment casing holes, as well as preventing contaminants from entering the machine interior. When cleaning, it is not only necessary to maintain cleanliness, but also to remove rust.

For cleaning and maintaining the motor, we can use cleaning agents and lubricants. In addition to these cleaning points where clean lubricants and transparency are the most important, it is also best to have some cleaning work. For example, if the anti high temperature of the right bearing end of the motor deepens, the side gap and motor end cover should be cleaned.

These cleaning tasks usually cannot avoid bearing contacts of the motor. Therefore, the operator only needs to pay attention to cleaning and maintenance, and only use cleaning solution or lubricant to clean and eliminate the cause of the fault. These are common faults in cleaning and lubrication. After cleaning and lubricant deterioration, the dirt on the surface of the motor can also be removed, but it is more difficult to remove the dirt.

When cleaning and lubricating the motor, care should be taken not to cause impurities to invade it, in order to avoid bearing damage.

The advantages of cleaning and lubrication: (1) The space of the cloth strips that are rubbed off is abundant, ensuring smooth sliding and reducing friction under any lubrication component. (2) Uneven friction area, such as lubricating cloth strips, lubricating rubber pads, etc.

Strong heat and easy to cause vibration and noise. (4) Blockage of air ducts, imbalance of permanent fan cooling holes or fan blades, resulting in blockage of air ducts or ducts, resulting in increased motor current.

Blade rotation and rotor binding and fixation force. These measures can be calibrated to change their robustness and reliability.

To ensure the safe operation of the motor, the windings of the motor should be made of thermosetting, suitable materials, and special insulation structures.

During the operation of the Sigma motor, there is often a risk of overload, rotor blockage, short circuit, and current interruption. The motor should have a starting device that allows the overload protection switch to be closed when stopped to prevent misoperation and withstand the operating machinery.

The Sigma motor includes a casing and rotating components, which rely on the load and working conditions of the motor. Therefore, the power factor of the motor is high, the temperature of the casing increases, and the cast iron motor is high.