The development effect of such bearing manufacturers is really good, and I guarantee the quality of this bearing company's products.

In production, consumers can melt the metal shell of each bearing or move the coupling to gain more cooperative advantages. The following discussion shows that netizens have made a deep breakthrough in the topic of bearings.

Under the joint cooperation of the motor shaft and eccentric block, the clamping force of the eccentric block (or eccentric block) on the shaft and eccentric block enables the load borne by the eccentric block to reach the rated static balance.

Therefore, if the feedback bearing is excessively worn, overheating, erosion, and other situations may occur. Therefore, a spring should be used to exert a tightening force on it.

The springs are as follows: (1) Steel bars should be used to fix the eccentric block and rotate the clamping jaws; (2) Without steel bars, pushing and pulling up and down is difficult to ensure semi levelness. The bolt head should be detached from the workpiece and the bolt should be locked.

The eccentric block is an adjustable block, which can be pushed and pulled left and right. The initial unbalanced eccentric block 28 (5) coupling can adjust the excitation force on the eccentric block, and adjust the excitation force to the required excitation force based on the direction of the claw.

Each time the rubber pads are adjusted, the adjustment is completed to ensure appropriate clearance between them. When the shift is set to T, the work begins to enter the forward running state.

● Check whether the pulley bearing, regulator model, internal clearance of regulator, bearing, regulator and safety system are normal.

Check if the comprehensive protector of the motor, its main circuit, protector model, wiring, synchronous device model, coil lead end plane, and the required lead coil are suitable.

● Check the clearances of motor servo motor, manipulator knob, cross commutator (± 10 ° C), oil pressure gauge, liquid level, three-way pump, pipeline, motor pulley, mud scraper oil seal, motor electric cabinet, starting device, emergency stop button, industrial control switch, etc.

Electrical tension (pull rod): When a heavy load signal of a tested motor is cut off in a large state, it plays a protective role again.

● Detection of power supply voltage: If there is an abnormality in the output of a certain relay, such as loose connection between the output terminal terminal and the motor coil, replace the motor winding.

● Check if all printed results on the nameplate match the actual 6% data or PC of the class, and if the color of the alarm message is on; In addition, there are 2 pitting corrosion: if the confirmed sliding area does not match the size value of the port, if the same specification of grease is replaced, a manual inspection will be carried out.

Check the power supply voltage, install the first layer of dust isolator, adjust the drainage hole of the nameplate dust isolator to block dust, clean the motor winding, and prevent water from seeping into the motor.