Do you really understand the manufacturer of this ball bearing? As a professional guide for the inspection and maintenance of bearings in large parts of famous food machinery, the following is a brief introduction to its inspection and maintenance.

For small mechanical motor spindles, if the machine tool guide rail and aperture direction are both connected, the fixed part should be tightened, and the bearing fastening bolts should be tightened to prevent the idle block in the large guide bearing room from breaking during rotation; If there is no oil deflector or iron door handle near the base and bearings, the cylinder should be forcefully twisted to drive the load. When the casing rotates, the eccentric block, pressure plate, cylinder sleeve, etc. pushed by the cylinder should maintain their immediate value, such as fixing the fixed ear and air gap;

For small mechanical motor spindles, in order to prevent unsafe operations, appropriate materials and tools should be selected to ensure that they cannot approach the bottom working surface of the workpiece.

For high-speed spindle machines and speed regulating motors, in order to ensure abnormal operation, the working voltage of the motor should be adjusted appropriately to avoid working at the rated voltage as much as possible.

For low-speed spindles, when the speed is below 4 poles and the force must be maintained, they should be adjusted according to the manufacturer's speed regulation method, and generally should work at a speed less than 7 to 12 times.

It is strictly prohibited to set the low-frequency characteristics when the low-speed spindle and speed regulating motor are running, especially when metal chips, hard objects, and strong magnetic field saturation may occur on the low-speed spindle. This is a high polarity temperature, which can damage the winding as a heat treatment method.

When the working power is not used for a long time, turn on the brush again and you can use a brush of the same model and specification.

In short, if the brush is properly installed and damaged during use, it will cause wear and tear on the entire brush holder, affecting the working efficiency of the brush. Therefore, when using brushes, it is important to pay attention to the above three aspects to ensure the correct installation and application of the brushes< Eod>.